Skip to main content

6m Eaves Vent Pack

Roll Form Eaves Vents

  • Unroll the ventilator along the rafters and along the full length of the eaves and position centrally above the wall plate. The wall plate is the narrowest part of the roof, where the roof insulation is most likely to constrict the airflow
  • Push the corrugations down over the top of the rafters and secure using clout nails or staples

Over Fascia Vents

  • Fix the ventilators to the top edge of the fascia board using screws or nails through the fixing holes provided. Ventilation must be provided for the full length of the eaves and along both sides of the building to create a cross flow ventilation action.

Felt Support Panels

  • Fit directly on top of the over fascia vent and secure with clout nails driven into the top of the fascia board through the slots in the over fascia vent. Ensure that each panel is allowed to overlap the next and allow the rear of the panel to lay back on to the rafters
  • nbs plus
  • riba

Web Design by Bluestorm